How can I connect EM Lock with iScan?
This document explains how to connect Plate Lock, Strike Lock and Exit switch.
1) Connect EM Plate Lock to connector 'CN4'.
EM Plate Lock is connected between 'NC' (Normally Connected) and 'Gnd'
(Ground). Plate Lock +ve Pin to NC and -ve Pin to Gnd.
2) Connect Strike Lock to connector connector 'CN5'.
EM Strike Lock is connected between 'NO' (Normally Open) and 'Gnd' (Ground).
Strike Lock +ve Pin to NO and -ve Pin to Gnd.
3) Connect Exit Switch to connector 'CN1'.
EM Plate Lock is connected between 'NC' (Normally Connected) and 'Gnd'
(Ground). Plate Lock +ve Pin to NC and -ve Pin to Gnd.
2) Connect Strike Lock to connector connector 'CN5'.
EM Strike Lock is connected between 'NO' (Normally Open) and 'Gnd' (Ground).
Strike Lock +ve Pin to NO and -ve Pin to Gnd.
3) Connect Exit Switch to connector 'CN1'.
Created by
zopeuser
Last modified 2008-01-17 18:18
Last modified 2008-01-17 18:18