How can I connect EM Plate Lock with Bio access?
EM Plate Lock interface with Bio Access.
On the back side of the Bio access unit you will connector "CN3", the EM Plate Lock and Exit Switch is connected to this connector.
CN3 Connector Discription:
Pin no.1-> Common
Pin no.2-> Normally Open (NO)
Pin no.3-> Normally Close (NC)
Pin no.4-> Exit switch
Pin no.5-> Ground
Note: You will find cut near Pin no.1.
EM Plate is connected between Pin no.3 and Pin no.5 (NC and Ground). Exit Switch is connected between Pin no.4 and Pin no.5.
Created by
zopeuser
Last modified 2008-01-17 18:18
Last modified 2008-01-17 18:18